APF-03 Aerial Work Platform

• Ideal for Aerial and Taut Sheath Splicing
• Versatile Mounting Configurations [Strand or Pole]
• Light Weight and Portable
• Designed to Meet FTTH Requirements
• Can Be Used With All Available Sumitomo Fusion Splicers
• Strand Safety Strips With Splicer Lanyard
• No Special Tools Required

 FTA-02 Fiber Arrangement Tool

• Organizes Individual Fibers into Ribbons for Mass Splicing
• Ribbons Can be Made With 2 to 12 fibers
• Creates a 4-inch Ribbon in Two Simple Steps
• Ribbon Can be Completed in Less Than 3 Minutes, Including Adhesive Drying Time
• Finished Ribbon can be Stripped, Cleaved, and Spliced Similar to a Manufactured Ribbon
• Enough Materials In the Consumable Kit to Construct 60 Ribbons.
• Compatible with All Sumitomo Mass Splicers

 FPS-1,FPS-6.1(New Thin 60mm Sleeve),FPS-6,FPS-26,FPS-40 Fiber Protection Sleeves

• RoHS Compliant
• New Slim Sleeves with Pre-Shrunk Single Opening Ends to Improve Fiber Placing Accuracy and Quicker Shrink Times
• Fully Restores the Environmental and Mechanical Integrity of the Coating Buffer Tube After Fusion Splicing
• Pre-Shrunk to Prevent Components From Separating While Being Handled
• No Sharp Edges to Damage Bare Fiber
• Stainless Steel and Glass Ceramic Strength Members Hold up to Harsh Environmental Conditions
• Designed to Meet Telcordia Standard TA-NWT-001380, “General Requirements for Fusion Splice Protectors”
• Ultrasonically Washed for Contamination Removal, Resulting in Higher Reliability

 Fiber Holders

• Tightly Controlled Tolerances On Fiber Holders Allow Proper Insertion Alignment In the Fusion Splicer
• Units are Purchased in Pairs
• Holders Use Magnets to Close the Covers Tightly, and Prevent Fiber Slippage
• Fiber Holders are Shipped in a Foam-Lined Plastic Carrying Case
• Fiber Holder Model Number is Clearly Marked on the Outside of Each Holder

 Click on Link Above to View Additional Accessories and Consumables